Sto VelariServis
Business hours
Closed until tomorrow
Directions
Pralietarskaja
1.61 km
Vielasipiedny zavulak
165 m
Features
Credit card payment
Parking
Wi-Fi
Basic service
Wheel alignment
Tire fitting
Wheel balancing
Vulcanization
Preliminary registration
Repair sevices:exhaust system repair, repair of brake system, engine repairs, full car sevice, oil changes, running gear repair, starter motor repairs, computer car diagnostics, car electrician repair, steering racks repairs, gearbox repair, generator repairs, repair of drive shafts, repair of cylinder head, webasto repair, RKPP repair, spare parts and accessories to order, replacing of timing belt, turbocharger repair
Brand:domestic cars, passenger car, foreign cars
Payment method:prepayment, cash, payment by card, cashless payment
Promotions:discounts, promotions
Similar places nearby
102 reviews
October 29
Service • Staff
I arrived with a specific problem identified during the inspection. I was told that I need to make a diagnosis. To the logical question, why would I do this if I already have the diagnostic results made 20 minutes ago, the answer followed: "I'm not clairvoyant enough to understand what's written here."
Conclusion: either the administrator is a complete layman who does not understand the relevant terms (then what is he doing here?), or he is trying to cheat for money, which is also bad for the employee responsible for quality.
I cannot evaluate the work of the masters, because after the administrator began to be openly rude, I left.
See original · Русский
July 6
I will also add to the last review: 10 thousand years ago. (or 6 months) I changed the oil with a filter in this car service (as it seemed to me) the oil was changed, but the oil filter was not. I found out about this only now at another car service (they said that your filter was not changed last time by anyone, judging by how rusty it was. I do not recommend this service. (Deception)
See original · Русский
September 26
Despite the declared engine repair services, the cylinder head refused to perform work on adjusting valve clearances (washers). As a result, I adjusted it myself: I bought probes, I had a micrometer. I removed the cylinder head cover, measured the gaps, purchased the required washers, put a new gasket, screwed the lid back on. The work is elementary.
See original · Русский